Reasons Why Your Nissan Qashqai Key Fob Won't Work

The Qashqai has a distinctly SUV-like appearance due to its larger dimensions, and the wheel sizes of 19 inches in Ti and ST-L models can be a bit firm at times. The front tyres of the Qashqai can also lose traction on rough surfaces, and the CVT may occasionally display a wrist-flexing torque steering.

This is typically caused by a dead battery, which can be replaced in just a few minutes. Make sure that the replacement nissan key fob battery is of the same voltage, size and specifications.

Water Damage

Water damage is one of the most frequent causes for the Nissan keyfob to display the "key ID is incorrect" message. The key fob has rubber seals that shield the electronic chip inside. However, prolonged exposure to moisture could cause it to cease functioning properly. This is often the case if you've dropped your key fob into the ocean or a swimming pools, but it could be the case if it gets wet from rain or soapy hands.

If your key fob was exposed to water for the course of a long time then you might need to clean it with isopropyl, or an electronic cleaner. Or, it could require taking to a professional to repair or replace it.

If your key fob does need to be replaced, the procedure is relatively easy. Make sure you have the right multipack (CR2032 3V). Remove the front and back cases with a flathead screwdriver. You'll have to remove the retaining clips made of metal and remove the battery that was in place, and then put in the new one. After reassembling the fob, put the mechanical key back into its place and make sure it works as expected. If not, you will need to take it to a local Nissan dealer or an experienced auto locksmith to fix the chip that controls the key. The chip is typically not damaged by water and therefore shouldn't be too expensive.

Dead Coin Battery

Another reason why your Nissan Qashqai key fob may not work is that the coin battery has gone dead. They typically last for 3 to 5 years, but they can become depleted over time, particularly if the fob is dropped frequently. You can replace the battery with a fresh one, but make sure that it's the same size and voltage as the original. If you're using another battery, it may cause the key to have an incorrect key ID which could prevent it from connecting to your vehicle.

The best method to replace the battery inside the Nissan Qashqai Key Fob is to pry it open using the help of a small screwdriver with a flat head. Insert the screwdriver into a small notch at the bottom of the fob, and twist it gently to split the two parts of the key fob. Then, remove the old CR2025 button cell battery and replace it with an alternative one after taking note of its location on the fob.

Examine the terminals to see if there is dirt or water damage prior to installing the new battery. If so clean the terminals with the smallest amount of isopropylethanol. You should also make sure the pole cables are connected properly - they must be connected to the positive and Nissan Qashqai Key Fob negative poles of the battery, respectively.

Troubleshooting

If your Nissan Qashqai key fob stops working after exposure to clean tap water or rain, it may be an indication of an internal chip problem. Change the battery won't fix this, and you'll have to buy an entirely new key fob. If the key fob stopped working after dropping it, it is likely that the chip inside was damaged. If you clean the chip with isopropyl ethanol and a paper towel and then insert it into the key fob, you will usually get it working again.

One common error you might see on the dashboard of your car is "Key ID Incorrect." This means that the car is unable to recognize the key fob and not allow it to start the engine. This problem can be caused numerous ways, including water damage, problems that are undetectable within the key fob circuitry or RFID interference.

The key fob will stop working in the event that the batteries with 12 volts are dead or fail to provide sufficient electric current. This will affect the remote keyless system and central locking on your replacement nissan key fob Qashqai, as well as hindering you from starting the engine with the key fob (if equipped with Intelligent Key). If you are unable to lock or unlock the door manually You should examine the batteries in the key fob to make sure they are in good condition. You can also try re-inserting the battery to reset the transmitter.

Reprogramming

If the key fob was not submerged into saltwater it should be able to be revived with a simple rinse of clean water. You can also clean the electronic chip by using isopropyl or electronic cleaner. If none of these methods work, you may need to replace the key fob.

If your nissan juke key fob Intelligent Key is still not working, it could be a problem with the connection between it and the car. To reconnect it, start by turning the key in the ignition, without turning on the car. Keep doing this until you see the warning lights flash twice. Then, turn the vehicle off and take away the keys.

Next, you must open the fob compartment inside your vehicle. It is typically located in the door jamb, on the handle for the driver's door or under an armrest. Find the button that says "program" and press it. You should hear a chime sound after the process is completed.

Now that your Intelligent Key is relinked to the car is the time to test it out. Stand some distance away from the vehicle and hit all the buttons on it. If the lights flash and the horn squeaks, it means that the key has been successfully linked to the nissan key fob replacement. You can also test it close to the Nissan.